Morgana Digifold 5000P - Operating the Digifold - Fold Type Guide; Gap Set Guide Table; Fold Type Illustrations

Page 14
CREASING / FOLDING
Half Fold on Knife 1
Half Fold on Knife 2
Half K1
Half K2
Letter
Concertina
Gate
Closed Gate
Engineering
FOLD TYPE GAP 1GAP 2GAP 3
GAP SET GUIDE
X
X
X
X
X
X
X
2X
X
X
X
X
X
X
2X
2X
3X
3X
3X
3X
3X
Double
X2X4X
HALF
LETTER
DOUBLE
CLOSED GATE
ENGINEERING
GATE
CONCERTINA
FOLD TYPES
The table below shows the recommended roller gap settings for the different types of folds.
Example 1:- When producing a fold, if GAP 1 is 0.2 (X) then set GAP 2 to 0.4
(2 x X) and set GAP 3 to 0.4 (2 x X).
Example 2:- When producing a fold, if GAP 1 is 0.3 (X) then set GAP 2 to 0.3 (X)
and set GAP 3 to 0.9 (3 x X).
Half K1
Gate
.
Operating the Digifold