Page 28
CREASING / FOLDING
Feeding Sheets Manually
In order to feed heavy stock, very small or very large sheets, embossed or even
irregular shaped sheets, it may be required to operate the machine manually.
The machine can be programmed and set up in exactly the same way as explained
when operating the machine automatically. However, when setting up the machine the
paper gate must be raised to its highest position for the sheets to be fed freely.
The machine can now be started by activating the System switch to ON.
Move the Selection Switch down to select
Wait until the suction drum rotates, before hand feeding the first sheet; (this allows the
machine time for the pre-feed checks to be processed). Subsequent sheets may be
hand fed as soon as the tail edge of the preceding sheet is no longer visible.
To stop feeding the sheets, move the Selection Switch up and then the System switch
Up.
IF the delay between feeding sheets is excessive, the system will time out and the
display will read ‘ ’.
If a sheet is fed after the time out it can be retrieved by lowering the delivery.
Do not
switch the Compressor switch on. Run.
NOTE.
Paper Didn’t Arrive
Operating the Digifold
To Next Page
Loading...
