Morgana Digifold 5000P - Set By Fold - Fold Type and Batching; Setting the Fold Type; Setting the Batch Quantity; Storing Programs

Page 20
CREASING / FOLDING
(Engineering)
Home
More
Set Type
Concertina
Batch Quantity 20
Home
More
Set Batching
Set Process,
Crease/Fold, Crease
Only, Fold Only Perf only
More
.
Set Type
Letter
Concertina, Half on K1, Half on K2, Double, Engineer, Gate Closed Gate
.
More
Batch Quantity
Back
More
7. Move the Selection Switch down to select the required crease or fold
option can now be set by moving the Selection Switch down to the required setting and
then moving the Selection Switch to the right. The options are
or
Move the Selection Switch to the right to select .
The can now be set by moving the Selection Switch down to the required
type and then moving the Selection Switch to the right. The fold options are ,
or ).
10. Move the Selection Switch to the right to select .
The batch quantity can now be set by moving the Selection Switch down and then
rotating the Selection Switch clockwise or anti-clockwise to adjust the
The Batch Counter controls the feed of the machine.
If for example the Batch Count is set to 10; the machine will feed 10 sheets of paper, pause
for approximately 5 seconds, the conveyor belt will feed the 10 sheets forward (to allow the
removal of the sheets from the conveyor) and then feed the next 10 sheets of paper.
11. Move the Selection Switch up to select .
12. Move the Selection Switch to the right to select .
Setting the Fold Type
Setting the Batch Quantity
NOTE.
).
8.
9.
Storing the Program.
Operating the Digifold