Trouble Shooting
Page 44
CREASING / FOLDING
Error Messages (Display Window Reads)
’Clip 1 was not clear’
’Clip 1 wasnt Blocked’
’Clip 2 was not clear’
’Clip 2 wasnt Blocked’
’Paper Jam’ ‘Inch Motor Drive’
(Back Sensor)
(Back Sensor)
(Top Sensor)
(Top Sensor)
If the machine stops and the display window reads this
indicates that the sensor is or was blocked when it should have been clear.
i.e. A jam in the paper path or the wrong length of paper has passed through the
sensor.
To correct - check if paper is present and check that the paper path is clear before
restarting. See pages 39 and 40 that describe how to remove paper jams.
If the machine stops and the display window reads this
indicates that the sensor did not see the paper at the correct time.
i.e. A jam in the paper path.
To correct - Check if paper has jammed in the machine prior to the sensor.
See pages 39 and 40 that describe how to remove paper jams.
If the machine stops and the display window reads this
indicates that the sensor is or was blocked when it should have been clear.
i.e. A jam in the paper path or the wrong length of paper has passed through the
sensor.
To correct - check if paper is present and check that the paper path is clear before
restarting. See pages 39 and 40 that describe how to remove paper jams.
If the machine stops and the display window reads this
indicates that the sensor did not see the paper at the correct time.
i.e. A jam in the paper path.
To correct - Check if paper has jammed in the machine prior to the sensor.
See pages 39 and 40 that describe how to remove paper jams.
In the event of a paper jam occurring whilst the machine is operating the
display window will read
See pages 39 and 40 that describe how to remove the paper causing the
Jam.
If the machine stops and the display window reads this indicates
that there is something blocking the edge sensor.
This indicates that the machine run program has found that the settings are not
capable of being run. (This should never happen).
Clip 1 was not clear
Clip 1 wasnt Blocked
Clip 2 was not clear
Clip 2 wasnt Blocked
Paper Jam.
Check edge sensor
‘Check edge sensor’
‘Blade error. Run stopped, Please check settings’
Try cleaning before suspecting a
total re-calibration of the 'Lead Edge Sensor'. The machine will not operate until it
can be sure nothing is already in the machine.
To Next Page
Loading...
