Morgana Digifold 5000P - Set By Fold - Initial Configuration; Power On and Safety Acknowledgment; Switching to Set By Fold Mode

Page 18
CREASING / FOLDING
Operate This Machine
No
Yes
Are You Trained To
Letter
Prog 1
Tota l 2 0
Reset
Setup
Adjust
Run
Batch Off
Letter
Prog 1
Tota l 2 0
Reset
Setup
Adjust
Run
Batch Off
Crease/Fold
Set By Posn.
Prog 1
Tota l 2 0
Reset
Setup
Adjust
Run
Batch Off
Crease/Fold
Prog 1
Tota l 2 0
Reset
Setup
Adjust
Run
Batch Off
Cr
SET BY FOLD
1. Switch the power ‘on’ by turning the Emergency stop button clockwise to release the
safety latch. The display is now switched on and will be as shown below.
If you have not been trained to operate this machine, we strongly advise that you move the
Selection Switch to the right to select . We recommend that you either seek training or
ask a trained operator to run the machine for you.
Move the Selection Switch to the left to select only if you have been trained to operate
this machine. If you have not been trained to operate this machine and you select ,
Morgana Systems Ltd accept no responsibility for personal injury, damage to the
machine or damage to materials being processed by the machine.
If the display contains the words as shown below, change to as
follows.
(i) Move the Selection Switch up to select and hold momentarily.
(ii) Move the Selection Switch down, one click at a time, to select .
(iii) Move the Selection Switch to the right.
IMPORTANT.
No
Yes
Yes
Set By Posn, Set By Fold
Reset,
Set by Fold
A typical, (SET BY FOLD), display menu is shown below.
Operating the Digifold