Trouble Shooting
Using the Correct Blade Set.
Two Blade sets are supplied with the machine.
The Standard Blade set is suitable for material thicknesses of 0.25mm (0.010”) and
greater.
The Narrow Blade set is suitable for material thicknesses of 0.25mm (0.010”) and
smaller.
If the Standard Blade Set is used to crease and fold materials less than 0.25mm
(0.010”) inaccurate results can be produced.
If the Narrow Blade Set is used to crease and fold materials greater than 0.25mm
(0.010”) cracking can occur. More importantly this could cause the main motor to
temporarily stall. This probably won’t be that noticeable until you look at the results,
whereby the crease position will vary.
Page 43
SYSTEM
Digifold 5000P
To Next Page
Loading...
