Morgana Digifold 5000P - Page 3

Page 3
SYSTEM
INDEX
THE BLADE ASSEMBLY
PAGE 29
30
REPLACING CREASING BLADE SETS
32
35
PERFORATING
36
37
REMOVING PAPER JAMS 39
‘Clip 1 wasnt Blocked’ 44
‘Check edge sensor’ 44
‘Blade error. Run stopped, Please check
Settings’ 44
‘Last crease is too close to the end of the
sheet’ 44
‘Double sheet detected’ 45
‘Overlap - Probable cause, double sheet’ 45
‘Blade Home Failure 2’ 45
‘45
‘NV checksum error 45
DISPATCH KIT 46
ACCESSORIES AND OPTIONS 47
RECOMMENDED SPARES 48 - 49
Adjusting the blade pressure
Adjusting the blade alignment
Installing new blade sets
Spare Blades
Equipment, Spares
Setting the machine
Display reads
Display reads
Display reads
Display reads
Display reads
Display reads
Display reads
Display reads
Display reads
TROUBLE SHOOTING
41
41
41
41
42
42
43
‘Clip 1 was not clear’ 44
‘Clip 2 was not clear’ 44
‘Clip 2 wasnt Blocked’ 44
‘Paper Jam’ ‘Inch Motor Drive’ 44
45
MACHINE CALIBRATION HISTORY SHEET 50
FUSE POSITIONS & RATINGS 51
PRODUCT RECYCLING AND DISPOSAL 52
Paper crease out of square
Paper fold out of square
Paper Jamming
Machine will not start
Paper not feeding
Cracking of the printed material along the crease
Using the Correct Blade Set
Display reads
Display reads
Display reads
Display reads
Recommended weekly operator maintenance
Crease Position Inaccuracy 41
Warning Blade pressure may be too high’
’
Digifold 5000P