7
and of transformer overload.
The device is not operative if no image appears on the screen. If the device becomes inoperative during
monitoring, a medium level type alarm sounds and the system resets automatically.
Regularly check all mains power cables for damage and proper connection. Do not use equipment with a
damaged power cord.
The Surveyor contains a lithium ion battery. The following precautions should be taken regarding the battery:
o
Do not immerse the device in water.
o
Do not heat or throw the device in fire.
o
Do not leave the in conditions over 60 ºC or in a heated car.
o
Do not attempt to crush or drop the device.
o
Only use the approved Mortara battery pack with the Surveyor monitor.
o
Follow the instructions in the disposal section of this manual when the Surveyor monitor is taken out of
service.
The Surveyor battery must be initially fully charged prior to use. Ideally, the battery must be fully charged and
fully discharged several times to allow for optimal performance.
The Surveyor produces audible startup tones when powered on (two tones followed by two higher beeps). If a
patient monitor does not sound the startup tones when it is powered on, remove the patient monitor from service
and contact Mortara Technical Support.
If the AC power supply is interrupted or disconnected during monitoring, the Surveyor switches to battery
backup if the battery is properly installed and has sufficient charge. If power is completely interrupted,
including exhausting the battery supply, monitoring will cease until AC power supply has been restored or a
fresh battery is installed, and the monitor’s power switch is recycled.
For continued operation, always connect the Surveyor to a wall outlet when a Low Battery alarm indication
occurs. Failure to do this can lead to an interruption of monitoring.
Ensure the battery has sufficient charge prior to disconnecting the external power supply. To disconnect from
the AC power, disconnect the external power adapter from AC power first, then disconnect the power
connection from the back of the monitor.
Always reconnect the power cord to AC power after operating the patient monitor using battery power. This
ensures that the batteries are recharged for the next time the patient monitor is operated on battery power. A
light next to the on/off switch will illuminate indicating that the patient monitor is connected to mains power and
charging. The battery icon on the main display indicates when the battery is fully charged.
To Next Page