ID Number. This feature is useful if you do not have a
programming Cable, Cloning Cable or PC easily available.
13.5.1
Configuring Cloning Mode Using
Wireless PROFILE ID Number
1 Turn the Source Radio on by performing the
following actions:
a Press PTT→Volume Down buttons at the same
time while turning the radio on.
b Wait three seconds before releasing the buttons
until you hear “Clone Mode Serial” voice prompt
from the Source Radio.
NOTE:
Serial cloning for Curve series is compatible
with DLR radios only.
a Press and release the Volume Down button.
You hear "Wireless" from the Source Radio.
2 Turn on the Target Radio by performing the following
actions:
a Press PTT→Volume Down buttons at the same
time while turning the radio on.
b Wait three seconds before releasing the buttons
until you hear “Clone Mode Serial” voice prompt
from the Target Radio.
NOTE:
Avoid putting powered on radios (more than
seven radios) in a container together, other
than the Multi-Unit Charger.
NOTE:
Serial cloning for Curve series is compatible
with DLR radios only.
3 To start the wireless PROFILE ID Number cloning on
the Source Radio, press and release the Volume Up
button.
• You hear a tone.
• After cloning is completed, you hear "Pass"
indicating cloning is successful or "Fail" indicating
cloning failed voice prompt from the Source
Radio.
• On the Target radio, the radio receives the
PROFILE ID Number information. You hear
"Pass" indicating cloning is successful or "Fail"
English
103
To Next Page
Loading...
