If... Then...
tone results in the first few words
of the transmission being cut out.
• Recharge, replace, or reposition
the batteries. See Battery Speci-
fications on page 21.
• Change to a location with no in-
terference.
If you hear
heavy static or
interference,
ensure that transmitting and receiv-
ing radios are at least five feet
apart.
If the Drop-in
Charger LED
light does not
blink,
perform the following actions:
1 Verify that the radio/battery is
properly inserted.
2 Check the battery/charger con-
tacts to ensure that they are
clean and charging pin is inser-
ted correctly.
Refer to Charging with the Drop-In
Tray Single Unit Charger on page
24, Radio Status on page 39 and
Attaching the Battery on page 32.
If... Then...
If the battery is
low,
recharge or replace the battery.
NOTE:
Extreme operating tem-
perature may affect bat-
tery life. See Battery
Specifications on page
21.
If low battery in-
dicator is blink-
ing although
new batteries
are inserted,
refer to Attaching the Battery on
page 32 and Battery Specifications
on page 21.
If the battery
does not charge
although it has
been placed in
the drop-in
charger for a
while,
perform the following actions:
• Verify that the drop-in tray charg-
er is properly connected and cor-
responds with a compatible pow-
er supply. See Charging with the
Drop-In Tray Single Unit Charger
on page 24 and Charging Stand-
Alone Battery on page 24.
English
108
To Next Page
Loading...
Need help?
General
