8-8 Disassembly/Reassembly Procedures: Radio Disassembly
8.4.5 Removal of the Back Kit Assembly (B)
This section contains instructions for disassembling the radio.
8.4.5.1 Removal of the Chassis (41)
1. With the Battery removed, disengage the Chassis (41) using the Chassis Opener as shown in
Figure 8-7.
Figure 8-7. Disengage the Chassis
NOTE: The Vacuum Port seal (43) and the Ventilation Label (44) must be removed each
time the Chassis is removed (for leak test).
2. After the Chassis (41) is disengaged, slide the chassis assembly down and lift it away from
the Front Kit (A) and lay both sub-assemblies on the anti-static mat (part of anti-static ground
kit) as shown in Figure 8-8.
Figure 8-8. Remove the Chassis Assembly
To Next Page
Loading...
