Motorola APX 1000 - Required Tools and Supplies

Disassembly/Reassembly Procedures: Required Tools and Supplies 8-3
8.2 Required Tools and Supplies
Table 8-2. Required Tools and Supplies
Tools
Motorola
Part Number
Supplier
Supplier
Part Number
Remarks
Chassis/Knob
Opener
PMLN7204A Horizon
Land Sdn.
Bhd.
14-8973 To remove chassis and knob from housing.
Bit, Torx T6 – – – For speaker retainer, back kit (chassis) and
keypad retainer.
Bit, Torx T8 – – – For top bezel screw.
Volume Switch
Spanner Nut
opener
TL000063A01 Brusia BE-MO-
143828
For Volume Switch Spanner Nut.
Driver, Torque – – – –
Black Stick – Hexacon
Electric Co.
MA-800G For keypad rubber mushroom rib assembly
and disassembly.
Round Stick – Brusia BE-MO-14383 For microphone membrane assembly.
Allen Wrench – – – To loosen accessory-connector cover thumb
screw (if thumb screw is too tight).
ESD Table Mat – – – To place radio and components during
disassembly and reassembly.
Vacuum Pump kit NLN9839_ Motorola – For vacuum test.
Vacuum Test
Fixture
TL000059A01 Brusia BE-MO-
141326
To connect the vacuum/pressure hose of the
Vacuum Pump Kit to the radio.
Vacuum Cap TL000061A01 Brusia VP6RSE To enhance sealing when the vacuum test
fixture is connected to the radio.
Pressure Test
Fixture
TL000062A01 Brusia BE-MO-
143143
To connect the vacuum/pressure hose of the
Pressure Pump Kit to the radio.
Pressure Pump
Kit
NTN4265_ Motorola – For pressure test.