8-4 Disassembly/Reassembly Procedures: Radio Disassembly
8.4 Radio Disassembly
This section contains instructions for disassembling the radio's main subassemblies.
Prepare the radio for disassembly:
• Turn off the radio by pressing on the MFK (22) and hold the MFK (Multi Function Knob) until the
radio display shows “Power off?”. Press the Menu Select button below and select Yes to power
off.
• Remove the antenna, the battery, the Accessory-Connector cover (14), the Bottom Label (17)
and any other accessory connected to the radio.
8.4.1 Remove Battery (48)
NOTE: The Motorola-approved battery shipped with the APX 2000/ APX 4000/ APX 4000Li radio is
uncharged. Prior to using a new battery, charge it per the recommended procedure for the
battery.
1. With the radio turned off, lift up the latch located at the bottom of the battery.
Figure 8-2. Lifting up the latch
To avoid a possible explosion:
• DO NOT charge, remove, or attach the battery in an area
labeled “hazardous atmosphere.”
• DO NOT discard batteries in a fire.
If the radio is programmed for volatile-key retention,
encryption keys will be retained for approximately 30 seconds
after battery removal.
To Next Page
Loading...
