Motorola APX 1000 - Figure 8-38. Engaging Hook and Seating Cover; Figure 8-39. Securing the Cover

8-26 Disassembly/Reassembly Procedures: Radio Reassembly
8.6.8 Reassemble the Accessory-Connector Cover (14)
1. Insert the hooked end of the cover into the pocket. Engage the hook beneath the undercut
and swing the cover down onto the radio. Ensure the cover is seated properly and the screw
is aligned into the threaded hole.
Figure 8-38. Engaging Hook and Seating Cover
2. Hand tighten the thumb screw clockwise until secured.
NOTE: Do not overtighten the screw. The screw should be snugged and does not allow the
cover to move.
Figure 8-39. Securing the Cover
Top Hooked End
Thumb Screw
Thumb Screw with Hex Head Socket