Motorola APX 1000 - Table 5-3. Test Frequencies (Mhz) - VHF, UHF1, UHF2

Performance Checks: Display Radio Test Mode 5-5
5.2.2 RF Test Mode
When the ASTRO APX 2000/ APX 4000 radio is operating in its normal environment, the radio's
microcomputer controls the RF channel selection, transmitter key-up, and receiver muting, according
to the customer codeplug configuration. However, when the unit is on the bench for testing,
alignment, or repair, it must be removed from its normal environment using a special routine, called
RF TEST MODE.
While in RF test mode:
• Each additional press of Side Button 2 advances to the next test channel. (Refer to
Table 5-3.and Table 5-4)
•Pressing Side Button 1 scrolls through and accesses the test environments shown in
Table 5-5.
•Pressing Top Side Button scrolls through the Tx Deviation Frequency.
NOTE: Transmit into a load when keying a radio under test.
Table 5-3. Test Frequencies (MHz) – VHF, UHF1, UHF2
Test
Channel
VHF UHF1 UHF2
RX TX RX TX RX TX
F1
136.075 136.025 380.075 380.025 450.075 450.025
F2
142.075 142.125 390.075 390.025 460.075 460.025
F3
154.275 154.225 400.075 400.025 471.075 471.025
F4
160.175 160.125 411.075 411.025 484.925 484.975
F5
168.125 168.075 424.975 424.925 485.075 485.025
F6
173.925 173.975 435.075 435.025 495.075 495.025
F7
– – 445.075 445.000 506.075 506.025
F8
– – 445.075005 445.000005 519.925 519.975
F9
– – 457.075 457.025 – –
F10
– – 469.975 469.925 – –