Motorola APX 1000 - Figure 8-33. Place Keypad Retainer over the Keypad Board; Figure 8-34. Torque in the Keypad Retainer Screws

8-24 Disassembly/Reassembly Procedures: Radio Reassembly
8.6.5 Reassemble the Keypad Retainer (28)
1. Place the Keypad Retainer (28) over the Keypad Board (27) in the Front Housing (16) as
shown in Figure 8-33.
Figure 8-33. Place Keypad Retainer over the Keypad Board
2. Torque all four keypad retainer screws (29) with a Torx IP6 Bit and a Torque Driver to 1.2 in-
lbf in the sequence as shown in Figure 8-34.
Figure 8-34. Torque in the Keypad Retainer Screws
1
2
3
4