8-16 Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
8.5.2 Servicing Chassis Assembly
Figure 8-23. Serviceable Components – Chassis Assembly
8.5.2.1 Servicing Ventilation Label:
1. Complete steps in Section 8.4.
2. Carefully peel off the label.
3. Use the Black Stick to help remove any difficult sections of the label.
4. Clean the area once the label is removed to ensure it is free from adhesive and debris.
5. Peel the new label off its backer and place in the respective location.
6. Apply slight pressure to set the adhesive.
Ventilation label should always be replaced when back kit
assembly is removed.
Microphone Boot
Battery Connector
Seal
Ventilation Label
Vacuum Port Seal
Main O Ring
Microphone Membrane
Microphone Flex
Back Microphone
Backer
To Next Page
Loading...
