Disassembly/Reassembly Procedures: Ensuring Reliable Splash Protection 7-31
7.7.5 Reassembly
Before reassembling the radio:
1. Inspect the Main O-Ring on the Chassis (26) for any damage or foreign material.
2. Inspect the Battery Contact Seal (29) on the Main Board Assembly (16) for any damage.
3. Inspect the mating seal surfaces on the Chassis (26) for all of the above seals for damage or
foreign material that might prevent the seals from sealing properly.
Continue reassembling the radio according to Section 7.6. Tighten all hardware that was loosened or
removed.
Do not reassemble the radio without first performing the
following preliminary inspection procedure.
To Next Page
Loading...
