42
General Radio Features
Programming a Scan List
To program a scan list, operator-selectable scan list members first
must be enabled in the radio programming by a qualified radio
technician.
Adding a Channel to the Scan List
1 Press the
button to scroll to the PROG softkey.
2 Press the button below PROG.
3 Press the
button to scroll to the SCAN softkey.
4 Press button below SCAN. The scan indicator blinks and
a good-key chirp is heard.
5 Press the
or button to scroll through the preprogrammed
scan list.
Press the SEL softkey to add the channel.
Scroll through of the available priority choices, and press the SEL
softkey to choose one.
The new channel becomes a member of the scan list assigned to
the selected channel when scan list programming was entered.
Note: If a scan list is full, you will hear a bad-key chirp each time
you press SEL softkey, and the desired channel will not be
assigned to the list.
Press the HOME button to exit scan list programming and return to
normal scan operation.
To Next Page
Loading...
