Motorola CP200XLS - Stop System Scan; Start Auto Scan G; Stop Auto Scan

33
English
SCAN
STOP SYSTEM SCAN
Press the preprogrammed Scan button to stop
System Scan (see page 17).
– or –
Note: Your dealer/programmer can preprogram
your radio when exiting System Scan to
automatically revert to the last scan channel/
talkgroup that had activity on it or to
automatically revert to the channel/talkgroup
where scan was initiated.
START AUTO SCAN G
Auto Scan automatically starts scanning once
a channel/talkgroup with Auto Scan enabled is
selected.
Select a channel/talkgroup that has been
preprogrammed for Auto Scan by your dealer/
programmer.
STOP AUTO SCAN
Select a channel/talkgroup that has not been
preprogrammed for Auto Scan by your dealer/
programmer.
• The Gsymbol disappears from the display.
3 L or M until
4 J to select
The display shows the current scan status.
5 L or M until
6 J to select the current setting.
1 J to enter menu mode.
2
L or M until
3 J to select
The display shows the current scan status.
SYS SCAN
SYS SCAN
SCAN ON
SYS SCAN
SYS SCAN
4 L or M until
5 J to select the current setting.
•The Gsymbol disappears from the dis-
play.
SCAN OFF