34
English
SCAN
DELETE A NUISANCE CHANNEL/
TALKGROUP
Note: Your dealer/programmer must preprogram a
button to access this feature (see page 17).
If a channel or talkgroup continually generates
unwanted calls or noise (a “nuisance” channel/
talkgroup), you can temporarily remove it from
the scan list:
Restore Channels/Talkgroups to the Scan
List
1 While the radio is on the nuisance channel/
talkgroup, press the preprogrammed
Nuisance Channel Delete button until you
hear a tone.
2 Release the Nuisance Channel Delete
button. The nuisance channel/talkgroup is
deleted.
Note: You cannot temporarily delete the
channel/talkgroup that has been
preprogrammed by your dealer/
programmer as your designated scan
channel/talkgroup, a priority channel/
talkgroup, or the last remaining
channel/talkgroup in the scan list.
1 Power OFF the radio. Once the radio is
powered on again, the deleted nuisance
channels/talkgroups are restored to the scan
list.
–
or –
Press the preprogrammed Scan button to stop
the scan.
2 Press the preprogrammed Scan button again
to start scanning again. The deleted nuisance
channels/talkgroups are restored to the scan
list.
–
or –
Select a channel/talkgroup that has not been
preprogrammed for scan by your dealer/
programmer to stop Scan. Once you return to
the original channel/talkgroup, the deleted
nuisance channels/talkgroups are restored to
the scan list.
To Next Page
Loading...
