Motorola Dimetra MTM300 - Reassembly; Figure 13 Disassembling and Reassembling Accessory Plug - Disassembly

Dash Mounting 15
.
Figure 13 Disassembling and Reassembling Accessory Plug - Disassembly
Reassembly
1. Insert the pin housing back into the shell in the opposite way it was removed. Be
certain that the 13-location side of the pin housing is facing the flat side of the shell.
Also be sure that the pin housing snaps securely into the shell and is not cocked in
the shell.
2. Install the cover back onto the accessory plug by snapping the cover over the tabs
and pressing down.
Tabs
Cover
(In Place)
Cover
(Removed)
Pin
Housing
13 Location Side
Flat Side
Shell
Wing
Win
g
Pin
Housing
Location Numbers
(Visible only when
wings are open)
14
24
25
23
22
20
19
21
18
17
16
15
A
B
D
C