Desktop Mounting 33
4. Install the radio onto the tray.
5. Plug the desk microphone cable into the connector on the radio’s front panel.
6. Mount the antenna outdoors (see page 36).
7. Connect the antenna cable to the antenna BNC connector located at the back of the
radio.
8. Connect the power supply DC cable to the DC connector located at the back of the
radio. Plug the other end of the power supply DC cable into the power supply.
9. Connect the power supply AC cable to the power supply. Plug the other end of the
power supply AC cable into a wall outlet.
Installation Instructions for Accessory Plug
When using the FLN2659 Data Adapter, do not use the accessory plug (see Figure 34,
page 32).
Disassembling and Reassembling Accessory Plug
Numbers for pin locations in the pin housing of the accessory plug are visible only when
the pin housing is removed from the shell and its wings are fully open.
Note
Note
To Next Page
Loading...
