Motorola Dimetra MTM300 - Control Head Installation; Figure 47 Control Head Mounting Trunnion; Figure 48 Ground Control Head as Shown; Table 6 Mechanical Parts for Control Head Mounting Trunnion (Motorcycle Version)

Motorcycle Installation 43
3. Secure the trunnion mounting bracket with the four screws supplied, ensuring that
the trunnion is grounded.
Figure 47 Control Head Mounting Trunnion
Table 6 Mechanical parts for Control Head Mounting Trunnion (Motorcycle Version)
Control Head Installation
1. Install the bushings into the trunnion (see Figure 47).
2. Slide the control head into the mounting trunnion until it snaps into place.
3. Hand tighten the wing screws (over-tightening with a tool will cause damage to both
the control head and the trunnion). After a few turns, tilt the control head for an
optimum view of the display. Then complete tightening of the wing screws.
4. Ensure that the control head is grounded. This should be done via one of the screens
that holds the connector at the back of the control head, see Figure 48.
Figure 48 Ground Control Head as Shown
Callout No. Motorola Catalogue No. Description
1 0305760W01 WingScrew(2)
2 4380128N01 Screw (4)
3 4380128N01 Bushing (2)
4 0780127N02 Trunnion (Metal)
Not shown 3202113U01 Gasket
Bushing
1
2
3
4
OR