Symbologies 10 - 39
Clear Transmission Buffer
To clear the transmission buffer, scan the Clear Buffer bar code below, which contains only a start character, a
dash (minus), and a stop character.
•
The digital imager scanner issues a short high/low/high beep.
•
The digital imager scanner erases the transmission buffer.
•
No transmission occurs.
Transmit Buffer
There are two methods to transmit the Code 39 buffer.
1. Scan the Transmit Buffer bar code, which includes only a start character, a plus (+), and a stop character.
2. The digital imager scanner transmits and clears the buffer.
•
The digital imager scanner issues a Low/High beep.
3. Scan a Code 39 bar code with a leading character other than a space.
•
The digital imager scanner appends new decode data to buffered data.
•
The digital imager scanner transmits and clears the buffer.
•
The digital imager scanner signals that the buffer transmitted with a low/high beep.
•
The digital imager scanner transmits and clears the buffer.
Clear Buffer
NOTE The Clear Buffer contains only the dash (minus) character. To scan this command, set Code 39 lengths to
include length 1.
Transmit Buffer
NOTE The Transmit Buffer contains only a plus (+) character. In order to scan this command, set Code 39
lengths to include length 1.
To Next Page
Loading...
