12
Press the Yes soft key (see “The Soft Keys” on page 13) if
you want to deactivate the TXI Mode – e.g. if you have left
the RF sensitive area where the TXI Mode was
recommended. If the MTM800 was previously used in
Trunked Mode (TMO), it will register to the network.
If you press Yes, and the terminal was previously used in TXI
and Direct Mode, it will exit TXI Mode and remain in Direct
Mode.
If the terminal was previously in Trunked Mode with TXI
enabled, pressing No will power off the terminal.
If you press No, and the terminal was previously used in TXI
and Direct Mode, it will remain in TXI and Direct Mode.
Key Overview
The Mode Key
The MTM800 has four major call modes when operating in
Trunked Mode Operation (TMO):
• Group mode — to send and receive Group Calls.
• Private mode — to send and receive Private Calls.
• Phone mode — to send and receive Phone Calls.
• PABX mode — to send and receive local (office) extension
numbers calls.
If configured by your Service Provider, Group mode is the
home mode to which the MTM800 returns automatically
when there is no activity for a few seconds in another mode
or in the menu.
Group mode can operate either in
•In Trunked Mode Operation (TMO) the MTM800 is used
with the infrastructure services within system coverage, or
•In Direct Mode Operation (DMO) the MTM800 is used
without infrastructure services required.
PABX mode will only be displayed if enabled by your Service
Provider
6815321H01_KOR.book Page 12 Thursday, November 13, 2008 8:06 AM
To Next Page
Loading...
