52
Operating with MTM800 in RF sensitive areas, see “Transmit
Inhibit” on page 38.
Entering the Private Number
Last Number Called
The last number called appears the moment the terminal
enters private idle mode. Press PTT to call this number.
Direct Entry
1. Enter the private number. If the number entered is in the
pre-stored private address book, the MTM800 will find it for
you.
2. To save the number in the address book, press
Save and
follow the prompts (see “Updating the Private Address
Book” on page 75).
Short Number Dial
If set up by your Service Provider, Short Dial allows you to
dial part of the full number of the person you wish to call. Your
MTM800 will automatically complete the number and send it
over the air based on your own terminal’s identity.
For example:
1. Dial 456 (instead of 4282456, the full number).
2. To place the call, press the PTT.
3. To hang up, press .
List Scroll
To scroll back or forward through the stored list of numbers
and names, press or .
While Transmit Inhibit is activated, an incoming Private Call is
indicated, but it is not possible to answer the call.
6815321H01_KOR.book Page 52 Thursday, November 13, 2008 8:06 AM
To Next Page
Loading...
