94
After completing the settings, the display returns either to the
Scan sub-menu or to Group mode.
To view the active scan list and its talkgroup status, see
section below.
Viewing the Active Scan List ( 7 2)
To enter the sub-menu,
press
– 7 Scan – 2 Active List.
This sub-menu allows you to view the
active scan list.
The display will show one of the following statuses:
• There is a selected, inactive scan list. Scanning is off.
• There is no selected scan list. Scanning is off.
• There is a selected, active scan list. Scanning is on.
To see the talkgroup status (active or not active) and priority
(if pre-programmed), press
View, and scroll through the
talkgroups.
Editing Scan Lists ( 7 3)
To enter the sub-menu, press
– 7 Scan – 3 ScanLists.
The display allows you to scroll through
the scan lists to see the number of
talkgroups used per list.
To edit/view the contents of a scan list,
press
Optns and scroll to your selection.
Press
Ok to select one of the following
options:
1.
Add a talkgroup to the selected scan list.
Every added talkgroup (including a fa-
vourite group) comes with its range, its name or number,
and its priority (if pre-programmed).
• To select a range, scroll through the range list. The list
does not show ranges whose talkgroups are fully used
in the selected scan list. Press
Ok to select a range.
Menu
Scan List 1
Active List:
Back
View
Menu
Menu
Menu
Used: 4
Scan List 1
Back Optns
Free: 36
1 Add Group
5 Clear List
Back
Ok
2 View List
6815321H01_KOR.book Page 94 Thursday, November 13, 2008 8:06 AM
To Next Page
Loading...
