95
The Menu
• To select a talkgroup, scroll through the talkgroup list
within the selected range. The list shows talkgroups that
are not in the selected scan list. Press
Ok.
• To set a priority to a talkgroup, scroll through the priority
list: high, medium, or low.
A call from a high priority talkgroup and with a higher
priority than the on-going call will interrupt it.
A call from a medium/low priority talkgroup will not interrupt
the on-going call.
2.
View the contents of the active scan list
(range, talkgroup, and priority if pre-
programmed) by scrolling through it.
3.
Edit the scan list talkgroups. Scroll to
your selection and press
Optns. Scroll to one of the
following options:
•To
Remove a talkgroup from the
selected scan list, select
1 Remove
Grp
and press Ok. You will be
prompted to remove the selected
talkgroup. After a few seconds, the display shows the
following talkgroup in the selected scan list.
• To change the talkgroup
Priority, select 2 Priority and
press
Ok. Scroll to the selected priority and press Ok.
After a few seconds, the display shows the new setting
of the selected talkgroup.
4. To
Rename the active scan list, enter a new name (alias)
and press
Ok. The display shows the new setting.
5. To
Clear all talkgroups from the selected scan list, press
Yes. You will be prompted to remove all talkgroups from the
selected scan list. After a few seconds, the display shows
the new setting of the selected scan list.
Talkgroup 1
Range 1
Back
Medium Prior
2 Priority
1 Remove Grp
Back
Ok
6815321H01_KOR.book Page 95 Thursday, November 13, 2008 8:06 AM
To Next Page
Loading...
