19
Getting Started
If configured by your Service Provider, your MTM800 will
display an internal Home Mode Display until another
message is received.
Time & Date
If your Service Provider configured this feature, you can
check time and date, by pressing relevant one-touch button.
Check in the menu options whether the Service Provider has
given you the capability of customising time and date
settings.
Terminal Disable/Enable
Your MTM800 is provided with a feature that allows your
Service Provider to disable it temporarily (in case it is stolen
or lost) wireless.
During the time your MTM800 is disabled, no calls can be
initiated or received.
While your MTM800 is disabled, it will
display the following blank screen.
Your MTM800 will act like it is turned off.
If you try to turn your MTM800 on when it is disabled it will
operate as described above.
If your MTM800 is found, your Service Provider can re-
enable it. After your MTM800 is re-enabled, you may resume
normal operation.
This feature is used as a special reminder message to the user.
Typically this would consist of a call sign, or work dispatch
reference number, or even for a train run number or bus route
number. New messages can be updated “over the air”.
6815321H01_KOR.book Page 19 Thursday, November 13, 2008 8:06 AM
To Next Page
Loading...
