1 - 4 WT4070/90 Wearable Terminal Integrator Guide
Getting Started
In order to start using the wearable terminal for the first time:
•
Install the main battery
•
Charge the main battery and backup battery
•
Start the wearable terminal.
Installing and Removing the Main Battery
Installing the Main Battery
Before using the wearable terminal, install a lithium-ion battery by placing the battery into the wearable terminal as
shown in Figure 1-4.
When a battery is fully inserted in a wearable terminal for the first time, upon the wearable terminal’s first power up,
the device boots and powers on automatically.
Figure 1-4
Installing the Main Battery
NOTE The main battery can be charged before or after installation into the wearable terminal. Use the Single Slot
USB cradle or Four Slot Spare Battery Charger to charge the main battery before installation, or the Single
Slot USB cradle or Four Slot Ethernet cradle to charge the main battery after installation.
NOTE Ensure the battery is fully inserted. An audible click can be heard as the battery is fully inserted. A
partially inserted battery may result in unintentional data loss.
To Next Page
Loading...
