Accessories 2 - 5
Communication Setup
The wearable terminal can communicate with a host computer using the Single Slot USB cradle. By default the
wearable terminal is configured to communicate using USB. Ensure that ActiveSync on the host computer is set to
allow USB connections.
1. Ensure that ActiveSync was installed on the host computer and a partnership was created.
2. Start ActiveSync if it is not running on the host computer. To start, select Start > Programs > Microsoft
ActiveSync
.
Figure 2-3
ActiveSync - Not Connected
3. In the ActiveSync window, select File > Connection Settings. The Connection Settings window displays.
Figure 2-4
Connection Settings
4. Select Allow USB connection check box.
5. Select OK to save any changes made.
6. Connect the device to the host computer.
7. Upon connection, synchronization occurs automatically.
NOTE Every wearable terminal should have a unique device name. Never try to synchronize more than one
wearable terminal to the same name. The device name is set in the System Properties window.
NOTE The cradle requires a dedicated port. It cannot share a port with an internal modem or other device. Refer
to the computer user manual supplied to locate the serial port(s).
To Next Page
Loading...
