Motorola WT4070 - Changing the Power Settings; Changing the Display Backlight Settings; Changing the Keypad Backlight Settings

Getting Started 1 - 9
• Set the wearable terminal to turn off after a short period of non-use.
• Set the display and keypad backlight to turn off after a short period of non-use.
• Turn on the keypad backlight only if needed.
• Turn off all wireless radio activity when not in use.
Changing the Power Settings
To set the wearable terminal to turn off after a short period of non-use:
1. Select Start > Settings > Control Panel > Power icon > Power Off tab.
2. Press ENTER.
3. Select the On battery power: Turn off device if not used for: check box and select a value from the drop-down list
box.
4. Press ENTER.
Changing the Display Backlight Settings
To change the display backlight settings in order to conserve more battery power:
1. Select Start > Settings > Control Panel > Backlight icon > Battery Power tab.
2. Press ENTER.
3. Select the On battery power: Disable backlight if not used for: check box and select a value from the drop-down
list box.
4. Select the Brightness tab.
5. Select the Disable backlight check box to completely turn off the display backlight.
6. Use the slider to set the brightness of the backlight. Set it to a low value to save battery power.
7. Press ENTER.
Changing the Keypad Backlight Settings
To change the keypad backlight settings in order to conserve more battery power:
NOTE To navigate using the keypad refer to the WT4070/90 Wearable Terminal User Guide.
NOTE To navigate using the keypad refer to the WT4070/90 Wearable Terminal User Guide.
Not applicable on the Voice Only WT4090.
Changing the Backlight setting on the Voice Only WT4090 will change the brightness of the Application
Controlled LED. Refer to the EMDK Help file WT4090-VOW Programming page for more information.
NOTE To navigate using the keypad refer to the WT4070/90 Wearable Terminal User Guide.
Not applicable on the Voice Only WT4090.
Changing the Keypad Backlight setting on the Voice Only WT4090 will change the brightness of the
WLAN Status LED. Refer to the EMDK Help file WT4090-VOW Programming page for more information.