Motorola WT4070 - Known Aps Window

5 - 32 WT4070/90 Wearable Terminal Integrator Guide
Figure 5-41 Trace Route Window
Enter an IP address or a DNS Name in the
IP combo box. Press TAB to highlight Start Test. Press Blue - BKSP. The
IP combo box should match the information shown in the
ICMP Ping window’s IP combo box. When starting a test,
the trace route attempts to find all routers between the wearable terminal and the destination. The Round Trip Time
(RTT) between the wearable terminal and each router appears, along with the total test time. The total test time
may be longer than all RTTs added together because it does not only include time on the network.
Known APs Window
The Known APs window displays the APs in range using the same ESSID as the wearable terminal. This window is
only available in
Infrastructure mode. To open the Known APs window, press 3.
Figure 5-42 Known APs Window
See Table 5-22 for the definitions of the icons next to the AP.
Using the navigation keys select an AP. Press
Blue key - TAB (Menu) to display a pop-up menu with the following
options:
Set Mandatory and Set Roaming.
Select
Set Mandatory to prohibit the wearable terminal from associating with a different AP. The letter M displays on
top of the icon. The wearable terminal connects to the selected AP and never roams until:
• You select Set Roaming
Table 5-22 Current Profile Window
Icon Description
Indicates that the AP is the associated access point, and is set to mandatory.
Indicates that the AP is the associated access point, but is not set to mandatory.
Indicates that the wearable terminal is not associated to this AP, but the AP is set as mandatory.
Indicates that the wearable terminal is not associated to this AP, and AP is not set as mandatory.