2 - 6 WT4070/90 Wearable Terminal Integrator Guide
Four Slot Ethernet Cradle
This section describes how to set up and use a Four Slot Ethernet cradle with the wearable terminal.
The Four Slot Ethernet cradle:
•
Provides 5.4 VDC power for operating up to four wearable terminals.
•
Enables data communication between the wearable terminal (up to four) and a host computer, over an
Ethernet network (using a standard 10Base-T Ethernet cable).
•
Simultaneously charges up to four wearable terminals (with batteries installed).
You cannot ActiveSync using the Four Slot Ethernet cradle. To ActiveSync with a host computer, use the Single
Slot USB cradle.
Connect the Ethernet cradle (Ethernet port 1) to an Ethernet hub or a port on the host device. Connect the Ethernet
cradle (power port) to an approved power supply.
CAUTION Ensure that you follow the guidelines for battery safety described in Battery Safety Guidelines on page
10-3.
CAUTION Use only an approved power supply output rated 12 VDC and minimum 9 A. Use of an alternative
power supply will void the product warranty and may cause product damage. See the WT4070/90
User Guide for the power supply regulatory compliance statement.
To Next Page
Loading...
