3
3
Chapter 3Software Installation
After installing the CA Series module in your embedded computer, the next step is installing the
software. Drivers for various operating systems are provided, including DOS, Windows, and
Linux. This chapter explains how to install and remove the CA Series driver.
The following topics are covered in this chapter:
Windows Vista (32-bit)
¾ Installing the Driver
¾ Using Device Manager to Verify
Installation
¾ Port Configuration
Windows XP, 2003 (32-bit)
¾ Installing the Driver
¾ Using Device Manager to Verify
Installation
¾ Port Configuration
¾ Using PComm
¾ Using Event Log
¾ Disabling the Module
¾ Uninstalling the Module
Windows 2000
¾ Installing the Driver
¾ Using Device Manager to Verify
Installation
¾ Port Configuration
¾ Using PComm
¾ Using Event Log
¾ Disabling the Module
¾ Uninstalling the Module
Windows NT
¾ Installing the Driver
¾ Uninstalling the Module
Windows 95, 98, Me
¾ Installing the Driver
¾ Uninstalling the Module
Linux
DOS
¾ Installing the Driver
¾ Driver Setup
¾
Loading the Driver
¾ Unloading the Driver
To Next Page
Loading...
