CA Series User’s Manual Software Installation
3-59
Loading the Driver
After setting up the driver, you must load the driver in order to gain access to the serial ports on
the module. Run BIN\DPC-DRV.EXE at the DOS prompt. The driver will detect your CA Series
module automatically. You should see messages indicating successful detection of your module,
such as the following:
PC/104 Communication Module DOS driver Version 1.0
Setup driver …
CA-104 series OK!
Device driver setup O.K.
At this point, you can execute applications that support API-232 functions, or start developing
applications using the API-232 library.
Unloading the Driver
To unload or release the CA Series driver from memory, enter DPC-DRV/Q at the DOS prompt.
To Next Page
Loading...
