Moxa Technologies EtherDevice EDS-510A Series User Manual

3
3
Chapter 3 Featured Functions
In this chapter, we explain how to access the EDS-510A’s configuration options, perform
monitoring, and use administration functions. There are three ways to access these functions:
RS-232 console, Telnet console, and web browser. The serial console connection method, which
requires using a short serial cable to connect the EDS-510A to a PC’s COM port, can be used if
you do not know the EDS-510A’s IP address. The Telnet console and web browser connection
methods can be used to access the EDS-510A over an Ethernet LAN, or over the Internet.
The web console is the most user-friendly way to configure the EDS-510A. In this chapter, we use
the web console interface to introduce the functions. There are only a few differences between the
web console, serial console, and Telnet console.
The following topics are covered in this chapter:
 Configuring Basic Settings
 Using Port Trunking
 Configuring SNMP
 Using Communication Redundancy
 Using Traffic Prioritization
 Using Virtual LAN
 Using Multicast Filtering

 Using
Bandwidth Management
 Using Port Access Control
 Using Auto Warning


 Usin
g Line-Swap-Fast-Recovery
 Using Set Device IP
 Using Diagnosis
 Using Monitor
 Using the MAC Address Table
 Using Event Log
 Using Syslog
 Using HTTPS/SSL

Moxa Technologies EtherDevice EDS-510A Series Specifications

General

Brand	Moxa Technologies
Model	EtherDevice EDS-510A Series
Category	Switch
Language	English