EDS-510A Series User’s Manual Featured Functions
3-4
Password
Setting Description Factory Default
Old Password
(Max. 16 Characters)
Type current password when changing the
password
None
New Password
(Max. 16 Characters)
Type new password when changing the password None
Retype Password
(Max. 16 Characters)
If you type a new password in the Password field,
you will be required to retype the password in the
Retype new password field before updating the
new password.
None
Accessible IP
The EDS-510A uses an IP address-based filtering method to control access to the EDS-510A
units.
Accessible IP Settings allows you to add or remove “Legal” remote host IP addresses to prevent
unauthorized access. Access to the EDS-510A is controlled by IP address. If a host’s IP address is
in the accessible IP table, then the host will be allowed access to the EDS-510A. You can allow
one of the following cases by setting this parameter:
Only one host with the specified IP address can access the EDS-510A
E.g., enter “192.168.1.1/255.255.255.255” to allow access to just the IP address 192.168.1.1.
Any host on a specific subnetwork can access the EDS-510A
E.g., enter “192.168.1.0/255.255.255.0” to allow access to all IPs on the subnet defined by
this IP address/subnet mask combination.
Any host can access the EDS-510A
Disable this function by deselecting the Enable the accessible IP list option.
To Next Page
Loading...
Need help?
General
