EDS-510A Series User’s Manual Featured Functions
3-16
“Turbo Ring” DIP Switch Settings
DIP 1 DIP 2 DIP 3 DIP 4
ON: Enables this EDS
as the Ring Master.
ON: Enables the
default “Ring
Coupling” ports.
ON
: Activates DIP
switches 1, 2, 3 to
configure “Turbo
Ring” settings.
Reserved for future
use.
OFF
: This EDS will
not be the Ring
Master.
OFF
: Do not use this
EDS as the ring
coupler.
OFF
: DIP switches 1,
2, 3 will be disabled.
“Turbo Ring V2” DIP Switch Settings
DIP 1 DIP 2 DIP 3 DIP 4
ON: Enables the
default “Ring
Coupling (backup)”
port.
ON
: Enables this EDS
as the Ring Master.
ON: Enables the
default “Ring
Coupling” port.
ON
: Activates DIP
switches 1, 2, 3 to
configure “Turbo Ring
V2” settings.
OFF: Enables the
default “Ring
Coupling (primary)”
port.
OFF
: This EDS will
not be the Ring
Master.
OFF
: Do not use this
EDS as a ring coupler.
OFF: DIP switches 1,
2, 3 will be disabled.
NOTE
The DIP 1 setting will only be active if DIP 3 is in the ON position. If you set DIP 3 to OFF, then
the default Ring Coupling port will NOT be enabled, even if DIP 1 is ON.
Protocol Default Turbo Ring Ports Default Ring Coupling Port(s)
Turbo Ring
ports G2 and G3 port 7
Turbo Ring V2
ports G2 and G3 port G1
NOTE
The Turbo Ring Ports and Coupling Ports will be added automatically to all VLANs if you set
DIP Switch 4 to the “ON” position.
NOTE
If you do not enable any of the EDS-510A switches to be the Ring Master, the Turbo Ring
protocol will automatically choose the EDS-510A with the smallest MAC address range to be the
Ring Master. If you accidentally enable more than one EDS-510A to be the Ring Master, these
EDS-510A switches will auto-negotiate to determine which one will be the Ring Master.
To Next Page
Loading...
