Moxa Managed Ethernet Switch (UI_2.0_FW_5.x) User Manual
SNMP Trap Mode—Inform
SNMPv2c, SNMPv3 provides an inform mechanism. When an inform message is sent f rom the SNMP agent
to the NMS, the receiver sends a response to the sender acknowledging receipt of the event. This behavior
is similar to that of the get and set requests. If the SNMP agent does not receive a response from the NMS
for a set period of time, the agent will resend the trap to the NMS agent. The maximum timeout time is 300
sec (default is 10 sec), and the maximum number of retries is 99 times (default is 3 times). When the SNMP
agent receives acknowledgement from the NMS, it will stop resending the inform messages.
SNMPv2C Inform
Host IP Address 1
IP or name
Specifies the IP address or name of the primary trap server
used by your network.
NA
1st Trap Community
Specifies the community string to use f or authentication.
Host IP Address 2
IP or name
Specif ies the IP address or name of the secondary trap server
used by your network.
None
2nd Trap Community
Specifies the community string to use f or authentication.
SNMP V3 version is based on SNMP V2c enhance security f eatures, through the identif ication and encryption
of data, providing the f ollowing security f eatures:
1. Ensure that the information must be sent f rom a legal source.
2. Encrypt the transmitted data to ensure the conf identiality of the data.
3. Use the password principle to ensure that the data of transmission process will not be tampered with.
To Next Page
Loading...
Need help?
General
