Need help?Do you have a question about the MR TAPCON 230 Expert and is the answer not in the manual?
General| Brand | MR |
|---|---|
| Model | TAPCON 230 Expert |
| Category | Controller |
| Language | English |
Explains symbols, signal words, and typographic conventions used in the manual.
Defines the intended purpose and conditions for safe device operation.
General safety guidelines for personnel, work areas, and operation.
Mandatory personal protective equipment required for safe operation.
IT security recommendations for device commissioning procedures.
Details of device communication interfaces, protocols, and ports.
Explains how the device maintains constant output voltage of a transformer.
Highlights key features like web visualization, automatic voltage regulation, and monitoring.
Describes Auto, Manual, and Local operating modes for device control.
Details of the device's display and control buttons.
Lists the necessary tools and materials for device mounting.
Specifies required clearances for ventilation and component spacing during installation.
Detailed instructions for connecting device cables and interfaces.
Recommendations for selecting appropriate connection cables.
Guidelines and requirements for maintaining electromagnetic compatibility.
Guide to establishing a connection for device visualization via interfaces.
Guidance on using the commissioning wizard for parameter setup.
Essential function tests to perform before switching to auto mode.
Step-by-step procedure to test the device's control functionality.
Ensuring correct parallel operation setup and parameters.
System settings including general functions, network, and time synchronization.
Configuration of network settings, IP addresses, and protocols.
Parameters related to power grid settings and transformer data.
Setting limit values for monitoring transformer output voltage.
Parameters for controlling the on-load tap-changer.
Parameters required for the voltage control function.
Compensation for load-dependent voltage drop using R&X or Z methods.
Functions and methods for operating transformers in parallel.
Parallel operation method for synchronizing tap positions via CAN bus.
Monitoring voltage deviations from the set bandwidth.
Settings and monitoring for the on-load tap-changer.
Control and monitoring parameters for the motor-drive unit.
Parameters for controlling the motor-drive unit's switching pulses.
Troubleshooting common device faults and their causes.
Troubleshooting steps for when the device fails to regulate in AUTO mode.
Troubleshooting issues related to parallel operation modes and CAN bus.
Electrical specifications for the device's power supply.
Technical specifications for voltage and current measurement circuits.
Details on various communication interfaces and their pin assignments.
Lists compliance with relevant EMC, electrical safety, and measurement standards.
To Next Page
