Need help?Do you have a question about the MR tapcon 230 pro and is the answer not in the manual?
General| Brand | MR |
|---|---|
| Model | tapcon 230 pro |
| Category | Controller |
| Language | English |
Essential guidelines for safe installation, connection, commissioning, and monitoring of the product.
Defines correct usage of the product to prevent hazards to people, property, or environment.
Specifies the required training and familiarity for staff operating electrical energy systems.
Outlines responsibilities for preventing accidents, disruptions, and damage during operation.
Outlines the different installation versions available for mounting the device.
Explains the procedure for mounting the device into a control panel cutout.
Describes how to mount the device on a wall using supplied mounting brackets.
Details the process for mounting the device onto a cap rail using a clip.
Guides on how to make the electrical connections to the device, including safety warnings.
Procedures to verify correct wiring and initial device setup before commissioning.
Overview of essential parameters to be set for device commissioning.
Details on setting transformer data, NORMset, and control parameters.
Outlines recommended function tests to perform before switching to auto mode.
Step-by-step guide to verify the device's core control operations in manual and auto modes.
Procedures for testing specific functions like undervoltage, overvoltage, and compensation.
Guides on testing parallel operation, including circulating reactive current and tap synchronization.
Introduces NORMset mode for quick voltage regulation setup, adapting parameters to grid requirements.
Details parameters for voltage regulation, including desired values, bandwidth, and delay times.
Explains how to set up to three different desired voltage values for regulation.
Covers setting the maximum permissible deviation in measured voltage for regulation.
Covers setting limit values for undervoltage, overvoltage, and overcurrent monitoring.
Explains how to set limit values and delay times for undervoltage monitoring.
Details how to configure overvoltage monitoring and the device's response to it.
Guides on setting limit values for overcurrent monitoring to prevent tap-changes.
Explains how to set limit values for undercurrent monitoring to block control.
Covers parameters and conditions for operating multiple transformers in parallel.
Troubleshooting guide for issues where AUTO mode regulation is ineffective.
Addresses causes and remedies for unexpected tap changes in the device.
Helps diagnose and resolve problems with inaccurate voltage or current measurements.
Covers troubleshooting steps for problems encountered during parallel operation.
Guides on resolving incorrect tap position display or capture issues.
Addresses common faults like no power, fuse issues, and relay chatter.
To Next Page
