8 Fault elimination
Maschinenfabrik Reinhausen 2014130 3550953/00 ENTAPCON® 230 pro
Characteristics/detail Cause Remedy
High EMC load Use shielded cables or external filters
Poor grounding Check the functional ground
Table 43: General faults
Other faults
If you cannot resolve a problem, please contact Maschinenfabrik Reinhau-
sen. Please have the following data on hand:
▪ Serial number
– Name plate (Outer right side when viewed from the front [► 20])
– Info screen ( > Info)
Please provide answers to the following questions:
▪ Has a firmware update been carried out?
▪ Has there previously been a problem with this device?
▪ Have you previously contacted Maschinenfabrik Reinhausen about this
issue? If yes, then who was the contact?
8.9
To Next Page
