EasyManuals Logo

MSA Ultima Series User Manual

MSA Ultima Series
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Using the ID CODE Feature
Controller operation can be password-protected to prevent operation by
unauthorized personnel. All Ultima Controller units are shipped from the
factory with Password ID disabled.
To Enable or Change the Password ID
1. With the unit OFF, press and hold the ENTER button for
approximately five seconds, until the display prompts:
ID KEY ####.
2. Use the NUMBER buttons:
To CHANGE password ID by entering the old ID number
(go to step 3)
To ENABLE a password ID by entering 9999.
3. Press the ENTER button.
The display prompts: NEW KEY ####.
4. Enter the desired four-digit ID and press the ENTER button.
The unit enters the READY mode and saves the ID password
required for future operation.
To Disable the Password ID
1. With the unit OFF, press and hold the ENTER button until the
display prompts: ID KEY ####.
2. Using the NUMBER buttons, enter the old ID number.
3. After entering the four-digit number, press the ENTER button.
The display prompts: NEW KEY ####.
4. Enter 9999 and press the ENTER button.
The unit enters the READY mode and disables the password
ID function for future operation.
NOTE: If the ID password is set and forgotten, contact an MSA
service representative.
Turning the Controller ON
Press the ENTER button.
The unit performs a self-test and displays the firmware version
for several seconds
If unit displays the Ultima READY or UltimaX READY prompt,
it is ready for use
1-4

Table of Contents

Other manuals for MSA Ultima Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MSA Ultima Series and is the answer not in the manual?

MSA Ultima Series Specifications

General IconGeneral
DisplayLCD with backlight
Communication PortsRS-485, Modbus RTU
Measurement RangeDepends on sensor connected
AccuracyDepends on sensor connected
Outputsrelays
CertificationsUL

Related product manuals