EasyManuals Logo

MSA Ultima Series User Manual

MSA Ultima Series
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
4. Observing the proper polarity as shown on the plastic holder, install
two new batteries in the holder.
5. If either end-cover was removed during removal of the back cover,
reinsert it in its original location. (The dark IR lens must be at
the top.)
6. If the dark IR lens at the top of the unit is dirty, clean with soapy
water and dry before reinstalling it.
The lens must be clean for proper operation.
7. With both lenses in place, replace the rear cover and re-install the
four case screws.
8. Turn unit ON to verify operation.
NOTE: Changing the controller batteries does not effect the
internal real time clock or stored programs; therefore, the
time and date values remain as previously set.
Determining a Low Battery Condition on the Ultima Calibrator
1. Turn unit ON by pressing any button.
Low battery results in a double beep for each key press
Normal battery results in a single beep for each key press.
To Install New Batteries in the Ultima Calibrator
1. Turn OFF the Calibrator and remove the four screws from the rear
of the Ultima Calibrator unit.
2. Remove the two AAA batteries from their holders.
3. Observing the proper polarity as shown on the plastic holder, install
two new batteries in the holder.
4. Re-install the back cover of the Calibrator.
5. Press any Calibrator button and listen for beep to ensure unit
is operational.
4-2

Table of Contents

Other manuals for MSA Ultima Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MSA Ultima Series and is the answer not in the manual?

MSA Ultima Series Specifications

General IconGeneral
DisplayLCD with backlight
Communication PortsRS-485, Modbus RTU
Measurement RangeDepends on sensor connected
AccuracyDepends on sensor connected
Outputsrelays
CertificationsUL

Related product manuals