MSA Ultima Series User Manual

Adding a New Program
There are eight programs available, 1 through 8. Each program accepts
one Ultima Gas Monitor command.
To enter a new program:
1. Press and hold the PROGRAM button until the display prompt
reads: ENTER PRGM #.
2. Enter the program number (1 through 8).
NOTE: A dual beep tone is heard for each entry during the
Calibrator programming mode.
3. Press the ENTER button.
4. Enter the keystrokes of the single Ultima Gas Monitor function
desired. When all of the keystrokes are entered, the Controller
saves them and displays: SAVING--- for three seconds.
5. Repeat steps 1 through 4, using a different program number to
program additional Ultima Gas Monitor functions.
Linking or Combining Programs
It is often necessary to send multiple programs to the Ultima Gas
Monitor. Program #9 allows the linking or combining of five of the
eight programs.
To Link Programs
1. Press and hold the PROGRAM button until the display prompts:
ENTER PRGM #.
2. Enter program #9 by pressing the 9 key.
• A dual beep tone sounds.
3. Press the ENTER button.
• The display prompts: LINK #.
4. Enter the program numbers (1 through 8) to be combined or linked.
• Only five programs can be linked.
5. Press the ENTER button.
• The Controller saves this sequence.
NOTE: Empty programs can be linked but are not sent.
3-20

MSA Ultima Series Specifications

General

Display	LCD with backlight
Communication Ports	RS-485, Modbus RTU
Measurement Range	Depends on sensor connected
Accuracy	Depends on sensor connected
Outputs	relays
Certifications	UL