EasyManuals Logo

MSA Ultima Series User Manual

MSA Ultima Series
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
format (e.g.: 4:00 P.M. = 16:00). (Leading zeros are required.)
a. If your entry is valid, press ENTER button to save this time.
b. If your entry is invalid, it will not be accepted; re-enter the
correct time or press the CLEAR button to cancel
and start over.
• The DEL button allows for correction during entry.
Setting the Internal DATE of the Controller
NOTE: Momentarily pressing the DATE button displays the
current date.
1. Place unit in the READY mode.
• Display prompts: "ULTIMA READY" or "ULTIMAX READY".
2. Press and hold the DATE button until the MM-DD-YYYY prompt
appears. (Leading zeros are required.)
3. Enter the current date using the NUMBER buttons.
a. If your entry is valid, press ENTER button to save that date.
b. If your entry is invalid, it will not be accepted; re-enter date
or press the CLEAR button to cancel and start this
procedure again.
• The DEL button allows for correction during entry.
When Sending a Command
to the Ultima/Ultima X Series Gas Monitor
1. The Controller must be READY prior to any key press.
2. To change any function on the Ultima/Ultima X Series Gas Monitor,
point the top of the controller directly at the clear face of the sensor
(FIGURE 1-2) and press the desired sequence of controller
buttons. (The controller must be pointed at the sensor when the
final button of sequence is pressed.)
The top surface of the controller must be within six inches of
the sensor face to enable reception
Each button pressed is acknowledged by a short beep
• The CLEAR button is acknowledged by a double beep
When invalid responses are entered, the controller resets
to the READY mode or re-prompts user for a correct entry.
Note on Resetting latched Alarms
When an Ultima/Ultima X Gas Monitor has an active latched alarm
1-6

Table of Contents

Other manuals for MSA Ultima Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MSA Ultima Series and is the answer not in the manual?

MSA Ultima Series Specifications

General IconGeneral
DisplayLCD with backlight
Communication PortsRS-485, Modbus RTU
Measurement RangeDepends on sensor connected
AccuracyDepends on sensor connected
Outputsrelays
CertificationsUL

Related product manuals