EasyManuals Logo

MSA Ultima Series User Manual

MSA Ultima Series
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
To Use Programs 1 through 8
1. Press the PROGRAM button.
The display prompts: PROGRAM #.
2. Enter the desired program number (1 through 8).
3. Aim the Controller at the Ultima Gas Monitor
and press the ENTER button.
The Ultima Gas Monitor responds immediately.
To use Program #9
1. Press PROGRAM key.
2. Enter number 9.
3. Aim the Controller at the Ultima Gas Monitor and press the
ENTER button.
The Ultima Gas Monitor responds to the first program.
4. Press the 0 key to resend the first program or press 1 to send the
next programs linked; if there are no other programs linked,
press the 1 key to end.
To use Program #0
Program #0 is used to send the previous command. Resending the last
command is useful if it involved a number of keystrokes. Program #0
will resend all of the commands except for the following:
• ZERO
CAL
• ADDRESS
INITIAL CAL OR INITIAL CALIBRATION
SET TIME on the Calibrator
SET DATE on the Calibrator
To resend any command except for those listed above:
1. Press the PROGRAM key.
2. Press the "0" key. (This is the number zero key, not the key
labeled ZERO.)
3. Aim the Controller at the Ultima Gas Monitor and press ENTER.
If the last command is one of the three listed above, it will not send that
command; instead, the Controller will send the preceding command.
3-21

Table of Contents

Other manuals for MSA Ultima Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MSA Ultima Series and is the answer not in the manual?

MSA Ultima Series Specifications

General IconGeneral
DisplayLCD with backlight
Communication PortsRS-485, Modbus RTU
Measurement RangeDepends on sensor connected
AccuracyDepends on sensor connected
Outputsrelays
CertificationsUL

Related product manuals