MST Impact NS5004 User Manual

NS50 wireless network switch
User Manual
Revision C
Chapter 3: Installation
© 2012 MST Global
Commercial in Confidence
32
Step
Procedure
Illustration
1
Remove the dust cap from the antenna port.
2
Connect the coaxial cable plug to the RP-TNC
jack on the NS50 and tighten the outer sleeve.
3
Insulate the connection using self-
amalgamating rubber tape. Start at the base of
the connection and pull back the rubber tape
backing.
4
Pull the tape tightly, and tape around the
connector at an angle until it is 25mm past the
end of the connection.

MST Impact NS5004 Specifications

General

Brand	MST
Model	Impact NS5004
Category	Switch
Language	English